Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFAAC Gate Installation in West Hollywood: What to Know First
We install and service FAAC gate operators across West Hollywood, from the flats near Santa Monica Boulevard up through the hillside drives off Sunset. A typical FAAC gate installation in West Hollywood runs $1,400 to $4,200, and most jobs are completed in one day, with the price locked before we start. As an independent FAAC service provider, we are not tied to the manufacturer - which means we quote honestly, use OEM or better parts where it matters, and stand behind the work with our 90-Day Done Right Promise.
This page is for homeowners in West Hollywood who already own a FAAC opener, or are about to, and want to know what installation actually involves: what fails, what it costs, and how to avoid paying twice for the same job. Call (323) 677-4063 and a live person answers, around the clock.
How FAAC Products Fail - and How We Fix Them
FAAC builds solid operators, but we see the same failure patterns repeat across West Hollywood driveways. Here is what actually goes wrong, by model line, and what we do differently:
- FAAC 400 Series (swing gates): The hydraulic rams on 415 and 412 models are stout, but their limit switches drift over time - especially on steep West Hollywood driveways where the gate fights gravity every cycle. The symptom is a gate that stops an inch short of closed, or bangs the post. We reset the limit switches and re-tune the deceleration ramp rather than telling you the ram is dead. Most of the time, the ram is fine.
- FAAC 760/770 Series (commercial sliding gates): These show up on multi-unit and hillside properties in West Hollywood. The wheel bearings on the gate itself wear before the operator does. A noisy gate with a chattering motor is usually a bearing problem, not a motor problem. We inspect the gate’s wheels and track before we ever open the operator housing - poor wheel alignment is what kills those motors early.
- FAAC E024U Control Board: The most common board failure we see is a burned relay from repeated short cycling on dirty photocells. The gate runs fine for years, then starts reversing mid-cycle or not closing. Big-name companies will quote you a whole new operator. We replace the relay or the photo eyes, clean the lens alignment, and send you home for a few hundred dollars instead of a few thousand.
- FAAC 391/392 (solar and low-voltage operators): These are popular on West Hollywood gates that sit far from the house with no easy power run. The failure we see most often is degraded battery terminals, not the battery itself. Corrosion builds on the rings, voltage drops, and the gate will not move. We clean or replace the terminals, test the battery under load, and move on - no parts ordered, no week of waiting.
- FAAC S800H (high-use sliding doors/gates): The magnetic loops and safety edges on these units are the weak point. When a gate reverses without anything in its path, we test the loop sensor first. Half the time it is a cracked wire in a conduit under a West Hollywood driveway. We run the continuity test on site before quoting a loop replacement, so you are not paying for a new loop when all you needed was a splice.
Our FAAC Gate Installation Process
Every FAAC job in West Hollywood follows the same path, whether we are installing a new operator or replacing one that has given up. No surprises, no change orders at the door:
- 1
You call, a person answers. You tell us what the gate is doing - or not doing. If it is an emergency, we work you in same-day in West Hollywood.
- 2
We look at the whole gate, not just the box. Hinges, post lean, track wear, wire condition. A new FAAC operator bolted to a sagging gate will fail within a year. We fix the foundation first.
- 3
Parts decision on the spot. We tell you where OEM matters - control boards, safety edges, rams on the 400 series - and where a quality aftermarket part works just as well for less. You decide, with our recommendation in plain language.
- 4
We install and wire, cleanly. Conduit where code requires it in West Hollywood, weather-sealed connections, proper grounding. No zip-tie wiring jobs. We have seen those; they are embarrassing.
- 5
We test the gate until it cycles clean, repeatedly. At least six full open-and-close cycles with obstacle checks on the safety loop. If it is not right, it does not leave the driveway.
- 6
We walk you through the final price, in writing, before you pay. That price is what you pay - quoted, agreed, and standing. Then we hand you the warranty card for the 90-Day Done Right Promise and our number.
What FAAC Gate Installation Costs in West Hollywood
Every FAAC job is different, but here is honest money for the three most common scenarios in West Hollywood:
| Scenario | Typical Range |
|---|---|
| FAAC operator replacement on a healthy existing gate (411, 760, 390) | $1,400 - $2,600 |
| Full FAAC swing gate install with new posts, gate frame, and operator | $3,200 - $4,200 |
| Control board or relay repair, photo eye replacement | $280 - $650 |
What moves the price: post condition, whether conduit exists, gate weight, and whether it is a hillside driveway that needs a heavier-duty operator. We quote all of it before we touch anything. Call (323) 677-4063 for a free estimate - no trip charge inside the county.
Why West Hollywood Homeowners Call Gatewood Fence & Gate for FAAC Work
Hal Gatewood has been fixing gates in and around West Hollywood since 2001, and most of his regulars know him from the stretches of hillside driveways up near Laurel Canyon where a busted hinge or a fried motor board can leave you locked out before your morning coffee. The name is on the shop, and the shop is down the road - that is the oldest accountability there is.
We are an independent FAAC service provider, which means we repair what can be repaired and replace only what is actually done. We weld on site, so your gate stays in your driveway. We also service LiftMaster, Mighty Mule, Ghost Controls, and DoorKing - so if you are weighing FAAC against another brand, we will tell you straight which one makes sense for your driveway and your budget. Calls are answered by a live person, 24/7. And every job carries the 90-Day Done Right Promise in writing: if it is not done right, we make it right, one call brings us back.
FAQs
We can often get a replacement FAAC operator installed within one day once parts are confirmed, and for emergencies we do work same-day into West Hollywood schedules. The honest limit is parts: some FAAC control boards and rams have local availability, and others need one to three business days. Call (323) 677-4063 and we will tell you exactly what we can do before you commit to anything.
We use OEM FAAC parts where they matter - control boards, safety edges, hydraulic rams on the 400 series - and quality aftermarket parts where they perform equally well for less. You get the choice, with our honest recommendation, before any work begins. The price is agreed up front, in writing, and that is the price you pay.
FAAC’s manufacturer warranty covers the operator itself, and we do not do anything to void it - no cut corners, no mismatched wiring, no non-compliant installs. As an independent FAAC service provider, we are not a factory-authorized dealer, so we will never imply the manufacturer endorses our work. What we do give you, in writing, is our 90-Day Done Right Promise on the labor and the install quality.
If the posts are square, the hinges are true, and the gate cycles clean - repair it. A $300 relay beats a $2,000 operator every time. We replace a FAAC unit when the gear train is shot, the ram is leaking past the seals, or the board has failed in a way that makes repair a temporary fix. Tell us what it is doing wrong and we will tell you what it actually needs - give us your number and we will call you back ourselves.
Yes. We handle the electrical run where code allows in West Hollywood, install the photo eyes and safety edges, and test the full obstruction detection before we call the job done. If there is a wiring or conduit job outside our scope, we will tell you on the estimate so you can bring the right person in - no surprises mid-job. Call (323) 677-4063 for a free estimate.
Call Gatewood Fence & Gate for Your FAAC Installation in West Hollywood
You need a gate that opens when you pull up and stays closed when it should. You need a quote that does not change at the door. And you need somebody who will answer the phone at 6 a.m. when the gate will not open and you are stuck. That is us. Call (323) 677-4063 any time - a live person picks up, day or night. Or stop by the shop and look us in the eye. The name is on the door.
Written by Hal Gatewood, Owner, Gatewood Fence & Gate at Gatewood Fence & Gate, serving West Hollywood and nearby areas.