Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFAAC Gate Access Control in West Hollywood: What to Know First
FAAC gate access control repair in West Hollywood typically runs $180 to $650 depending on whether we’re replacing a keypad, swapping a control board, or rewiring a phone entry system. We’re an independent FAAC service provider and most jobs are done the same day we show up. You’ll know the price before we touch anything, and that price doesn’t change at the door.
This page is for West Hollywood homeowners with a FAAC gate operator who can’t get in with their remote, keypad, or phone entry and want someone who actually knows the brand. If that’s you, call (323) 677-4063 and a live person answers. Tell us what the gate’s doing wrong. We’ll tell you what it actually needs.
How FAAC Products Fail - and How We Fix Them
- FAAC E124 and S800 control boards burn out after power flickers. West Hollywood gets its share of brownouts and utility work along Santa Monica Boulevard and up into the hills. The E124 board’s relay contacts arc and stick, which is why your gate suddenly won’t respond to the remote but still opens from the keypad. We replace the relay or the board, then add a surge protector so it doesn’t happen again next month.
- FAAC 415 and 390 keypads stop reading digits because moisture gets behind the faceplate. The marine layer and morning fog off the Hollywood Hills is rougher on outdoor keypads than people expect. Buttons get corroded, codes drift, and you end up standing on the driveway punching your birthday into a dead pad. We open the housing, clean or replace the contacts, and reseal it so fog doesn’t creep back in.
- FAAC photocells on older 400-series operators go blind and misreport the gate as obstructed. The gate will start to close, then stop and reverse for no visible reason. Nine times out of ten the photocell lens is clouded or the wiring at the sensor got chewed up by the same landscape crew that’s been trimming the bougainvillea. We realign the beam, we replace the eye if the lens is shot, and we reroute the wire where the gardeners can’t hit it again.
- FAAC radio receivers (the RP series) drop their rolling-code memory after long idle periods. If you come back from two weeks away and every remote has suddenly gone dead, the receiver probably reset itself or its capacitor dried out. We reprogram and, when the receiver’s done for, install a compatible aftermarket unit that keeps your existing remotes working. On West Hollywood hillside properties, we also check antenna placement because the canyon walls block signal in ways flatland homes never see.
- FAAC hydraulic 770 and 390 operators leak fluid slowly and lose the strength to keep a heavy gate closed. A gate that eases open on its own or creeps shut an inch at a time usually means a weeping hydraulic seal, not a bad motor. We rebuild the cylinder or replace the seal kit on site and bleed the system, so you keep an operator that FAAC built to last instead of buying a whole new one because some other company couldn’t be bothered to find the leak.
Our FAAC Gate Access Control Process
- 1
You call. A live person picks up, day or night. You describe the symptom: remote dead, keypad ignoring codes, gate reversing, phone entry buzzing but not opening.
- 2
We show up in the window we promised. Hal or one of his crew arrives with FAAC-specific diagnostic tools and the common boards, receivers, and keypads on the truck. We test before we quote.
- 3
We show you the failure, not just tell you about it. If a board’s fried, you’ll see the burned relay. If a photocell’s out, you’ll see the dead beam. You decide with real information.
- 4
We fix it with OEM FAAC parts or a proven aftermarket equivalent. For warranty-sensitive items we use FAAC parts; for simple receivers and keypads we’ll offer a quality aftermarket option that costs less and lasts just as long. The choice is yours, and it’s on the written quote.
- 5
We test the gate through every cycle. Remote, keypad, phone entry, card reader, safety edges. The gate has to close clean a half-dozen times before we pack up. Hal genuinely can’t walk away from something that only works twice in a row.
- 6
You get the 90-Day Done Right Promise in writing. If anything we touched acts up within 90 days, one call brings us back. No runaround, no fresh invoice.
What FAAC Gate Access Control Costs in West Hollywood
Here’s what West Hollywood homeowners can expect to pay for common FAAC access control work:
- Keypad replacement or repair (FAAC 415, 390): $180 - $320
- Remote reprogramming or receiver replacement (RP series): $140 - $280
- Control board repair or swap (E124, S800): $280 - $520
- Photocell replacement and realignment: $160 - $250
- Phone entry or video intercom integration: $320 - $650
- Hydraulic seal rebuild (770, 390): $350 - $600
What moves the price is the age of the unit, whether we’re repairing or replacing a part, and how far up a hillside driveway we have to carry tools. Older FAAC 400-series operators sometimes need the board AND the receiver replaced together because they share a power rail. We’ll tell you that before we start, not after. Call (323) 677-4063 for a free estimate, and remember: a written quote from anyone else gets you a free second opinion here.
Why West Hollywood Homeowners Call Gatewood Fence & Gate for FAAC Work
Hal Gatewood has been fixing gates in and around West Hollywood since 2001, and he learned the mechanical side of things at Los Angeles Trade-Technical College down on Washington Boulevard. That matters on a FAAC job because the hydraulic 770 and the E124 board don’t fail the way a LiftMaster or a DoorKing fails. If you’re working on all of them every week, you stop guessing.
We also service LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, which means if your FAAC operator is genuinely beyond saving and a replacement makes more sense, we can talk honestly about what fits your gate and your budget. No commission-driven upsell because we’re not a sales crew. We’re the local shop with a published address, a live person on the phone 24/7, and a 90-Day Done Right Promise stamped on every job. The name is on the shop, and the shop is down the road. That’s the oldest accountability there is.
FAQs
No. As an independent FAAC service provider, we use OEM parts where warranty coverage matters and we never modify a unit in a way that would void the manufacturer’s terms. If your FAAC operator is still under warranty, we’ll tell you and we’ll work within those rules. Call (323) 677-4063 and ask, we’ll tell you straight.
Most common FAAC keypads, receivers, photocells, and boards are on our trucks because we stock for the hillside properties we already serve. Oddball hydraulic seals or older 400-series parts usually take two to three days from our local distributor. We don’t make you wait on a part without telling you the timeline up front.
If the operator is less than 10 years old and the failure is the board, receiver, keypad, or a hydraulic seal, repair almost always makes better sense. A $300 board beats a $2,500 replacement. If your FAAC is 20 years old and the housing is cracked through, we’ll be honest about replacement and we’ll price it so the number doesn’t surprise you. Hal fixes what can be fixed and won’t sell you a new unit just because it’s easier for him.
Most FAAC gate access control calls in West Hollywood get same-day or next-day service, and emergency calls where you’re stuck outside your own driveway get priority. A live person answers the phone around the clock, so you’ll know your window before you hang up. Call (323) 677-4063.
Yes. We run the low-voltage wiring, mount the unit, program the directory, and test it with your actual phone. If you’re adding a video intercom to an existing FAAC operator, we’ll tap into the board’s input correctly so the gate opens on the first ring, not the third. Estimates are free.
Written by Hal Gatewood, Owner, Gatewood Fence & Gate at Gatewood Fence & Gate, serving West Hollywood and nearby areas.