Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterLinear Gate Access Control in West Hollywood: What to Know First
Linear gate access control in West Hollywood means keypads, remotes, phone entry, card readers, and video intercoms wired into the gate operator that opens your driveway. We service all of it as an independent Linear service provider, usually same-day or next-day, and the price is quoted and agreed before any work starts. Most Linear access problems we see are not the operator itself. They are a keypad with corroded contacts, a receiver board that lost its programming, or a phone entry unit that no longer talks to the motor. This page is for homeowners who own a Linear system, know it worked fine for years, and now it does something wrong. Call (323) 677-4063 and a live person picks up.
How Linear Products Fail and How We Fix Them
Linear made thousands of gate access systems over the years, and in West Hollywood we see a handful of specific failure patterns repeat themselves. Here is what actually goes wrong, and what we do about it.
- Linear Multi-Code 3089 / 4120 keypads and the dying keypad membrane. The 3089 and older 4120 keypads are everywhere in the hillside neighborhoods above Sunset. The membrane buttons crack from sun exposure, and coastal moisture creep gets into the circuit board. The symptom is always the same: some buttons work, others need a hard press, and eventually the keypad eats the code. The fix is usually a new membrane and board cleaning, not a whole new keypad. If the housing is intact, we rebuild it.
- Linear MegaCode (MCT, MG series) receiver drift. The MegaCode receivers lose their programmed transmitters after power flickers, which West Hollywood gets plenty of during Santa Ana wind season. The owner swears the remote worked yesterday. It did. The receiver simply forgot the remote’s rolling code. We reprogram and, on the older MG boards, add a small backup battery so a five-minute outage does not wipe the memory again.
- Linear AE-100 telephone entry system and the dead relay. The AE-100 is a workhorse, but its relay contacts arc and pit over time. The gate stays locked because the relay clicks and does not close the circuit. A lot of companies quote a whole new telephone entry system for a ten-dollar relay. We replace the relay on the board, which is real work but honest work, and the system goes back into service.
- Linear APeX and the fried transformer. The APeX series runs on a low-voltage transformer that sits inside the operator housing. In West Hollywood’s dry heat, those transformers cook. The operator hums, the access panel lights up dim, and the gate does not move. We swap the transformer with a quality aftermarket unit rated for continuous duty, not the factory one that failed the same way.
- Linear LRA and DRA receivers with broken antenna connections. The little whip antenna on the LRA and DRA receiver boards snaps off or corrodes at the solder joint. Range drops from a hundred feet to about ten. The gate only opens when the car is practically touching it. We re-solder and seal the connection, and range comes back. That one is a fifteen-minute fix we have done more times than we can count.
Our Linear Gate Access Control Process
- 1
You call (323) 677-4063. Hal Gatewood or one of his crew answers. You describe what the access system is doing. We give you a straight answer about whether it sounds like a board, a keypad, wiring, or the operator itself.
- 2
We show up with Linear parts on the truck. Keypads, receivers, relays, transformers, and wiring for the common series. No second trip because we guessed wrong.
- 3
We diagnose the whole system, not just the symptom. If a keypad is dead, we check the wires feeding it before we replace it. If the receiver lost programming, we check the power supply that caused it. Fixing the symptom without the cause means you call us again in three months.
- 4
We make the parts call with you. OEM Linear parts when the warranty matters and the part is available. Quality aftermarket when the OEM part is known to fail or is backordered for weeks. You always know which one you are getting and why, before we install it.
- 5
We test it in front of you. We cycle the gate a half-dozen times with the keypad, the remote, and any phone entry or video intercom. If it does not work clean every single time, we are not done.
- 6
We put the 90-Day Done Right Promise in writing. If anything we touched fails within 90 days, one call brings us back. No runaround.
What Linear Gate Access Control Costs in West Hollywood
Here are real numbers for common Linear access jobs we do in West Hollywood. These are ranges because we have not seen your gate yet, but they are close enough to plan around.
- Reprogram or re-sync a Linear MegaCode receiver or remote: $85 to $150
- Replace a bad relay on a Linear AE-100 phone entry board: $120 to $190
- Rebuild a Multi-Code 3089 keypad (membrane and board cleaning): $110 to $180
- New transformer for an APeX operator: $140 to $220
- Full new Linear keypad and receiver installed: $350 to $600
- Complete Linear phone entry or video intercom system installed: $800 to $1,400
What moves the price is whether we are repairing a board or replacing it, how far the gate is from the power source, and whether the wiring in the ground is still intact. We do not give a price over the phone and change it at your door. The number we quote is the number you pay. Call (323) 677-4063 for a free estimate.
Why West Hollywood Homeowners Call Gatewood Fence & Gate for Linear Work
We have been fixing gates in West Hollywood since 2001, and our name is on the shop. Hal Gatewood learned the mechanical side at Los Angeles Trade-Technical College, and most of his regulars know him from the hillside driveways up near Laurel Canyon where a busted hinge or a fried motor board can leave you locked out before your morning coffee. When a Linear system fails, we fix the part that failed. We do not sell you a whole new operator because a keypad died. And if your Linear operator is genuinely beyond saving, we service LiftMaster, Mighty Mule, Ghost Controls, and DoorKing too, so the replacement we recommend is the one that fits your gate, not the one we have in stock. Every call is answered by a live person, 24/7. Every job carries the 90-Day Done Right Promise in writing. The name is on the shop, and the shop is down the road. That is the oldest accountability there is.
FAQs
In most cases yes. We keep common Linear keypads, receivers, relays, and transformers on the truck, and we schedule West Hollywood calls on short notice. Call (323) 677-4063 and tell us what the system is doing. We will give you a straight answer about when we can be there.
If your Linear operator or access device is still under an active factory warranty, we use OEM parts and follow the manufacturer’s repair practices so the warranty stays intact. If the warranty is long expired, which is most of what we see, we recommend the best part for the job and tell you why before we install it.
Repair is almost always cheaper, and we lean that way hard. The exceptions are when the operator is over 20 years old and the board is discontinued, or when the access system has been hit by lightning or water and multiple components failed at once. We will show you the condition, tell you the price both ways, and let you decide. We never push a replacement on a gate that has good years left.
It includes the keypad, card reader, phone entry, or video intercom, the receiver or controller, wiring, wiring protection, connection to the gate operator, programming for all remotes and codes, and full testing. We handle the power run and the safety edges too. You get one price for the whole job, agreed before we start, and the 90-Day Done Right Promise in writing.
Yes, and in West Hollywood it usually is rain or sprinkler water getting into a housing that was not sealed properly by whoever installed it. We find the leak, repair the board if it is salvageable, and seal the housing so it does not happen again. If the keypad is too far gone, we replace it and seal the new one correctly.
Tell me what it’s doing wrong and I’ll tell you what it actually needs. Give me your number and I’ll call you back myself. For Linear gate access control in West Hollywood, call (323) 677-4063. We answer live, 24/7, and the estimate is free.
Written by Hal Gatewood, Owner, Gatewood Fence & Gate, serving West Hollywood and nearby areas.